Quote:
Originally Posted by DavidVizard-GFN
Chris,
Well someone has the courage to step up to the plate. Good for you. GFN is willing to do all the testing for free but that does not include instalation. I have a stock Chevy Blazer (1997) in near as new condition mechanically and a 2005 2.0L Ford Focus. would either of these be good candidates??
DV
|
Hi Dave,
Sorry I have been so busy lately we have had a number of family members in the hospital for various reasons this past month. Installation should really take nothing more than some of your time and the following items:
10GA or heavier wire from an old pair of jumper cables (in good condition obviously)
A small switch (free?)
An in-line Amp meter with a 50A shunt (24 bucks from AllElectronics.com)
An automotive grade Relay rated for at least 50 or 60 amps (McMaster.car has nice ones 100A waterproof for 20 bucks)
Some small gauge wire for the meter and switch
My Electrolyzer
I also believe I found a way around the 02 sensor issue; at least on my new Buick. I will have to take a picture of what I'm talking about but there's a small nipple covering a port right on the very top of the engine. When I pull the little rubber nipple off and connect my vacuum guage up to it, it registers about 25 inches of Mercury vacuum as soon as the engine is started. Well folks this is damn near perfect!
It appears to be after all of the sensors basically sitting right on top of my engine block. -Again I'm not a car guy here so please forgive me. It's the solid cast aluminum piece (Manifold?) on top that has this little port.... probably for diagnosing leaks? -So I'm thinking this will be the perfect place to inject the hydroxy. It's well after the 02 sensor, perhaps 20 or more inches.
So where are you located Dave? I'm in Lancaster, PA. If you're close enough maybe we can work something out to get one of my units into your test vehicle. I would imagine that either one is fine to use. As I stated before I have been working very hard on the electrolyzer side of things for the past 6 years and have one of the most solid electrolyzer units you will ever find for an automobile. But my knowledge abruptly ends at the end of my hydroxy tube.